First of all, open your hood.
Take a chair and sit in front of one of your BMW E46 headlights and get the following things ready:
-Yours at www.Bimmer-Garage.de purchased Angel Eyes.
-Slotted screwdriver (lever tool)
1st
First we pull the rubber seal, the
located on top of the headlight.
2nd
Now the indicator comes out.
Place the screwdriver into the hole at the top and press down the indicator clip.
At the same time, you can pull the indicator forward.
Now we loosen the headlight clamps with a
Screwdriver oA (3 Top / 3 Bottom / 1 Left(inside)
To do this, you also have to pull out the lower panel.
4th
Now remove the headlight glass including the seal.
Grab the black plastic cover with both hands and
pull it forward.
5th
Now pull out the parking light from the engine interior, as this is now
one of the ring lights is being replaced and we need the hole for wiring.
6th
Take a look at your Angel Eyes package.
Attach a clip to each ring.
In the middle you push it from bottom to top onto the
guide and then tilt the clamp backwards.
Now move a bracket to the left and do the same again.
to position the second one on the right.
The cables are routed above the headlights, but below the
Headlight lens mounting clamps moved to the rear.
We insert the cables through the hole of the parking light.
You can now attach the angel eyes with the clamps.
The areas that touch the headlight can be
you from the inside of the rings with the enclosed
Equip adhesive pads.
9th
Now the headlight can be closed again.
To do this, follow steps 4 to 1 in reverse order.
Repeat the whole process for the other headlight.
10th
Regarding cabling, please refer to
you to our blog "https://www.e46-tuning.com/blogs/tutorial/angel-eyes-e46-tuning"
You can find our shop at
www.Bimmer-Garage.de